In English is called cornerload.Side load error. Deviation which occurs in the results when weighed an object by placing it in different positions of the saucer of weighing. Continue to learn more with: New York Museums. For example: between the Center plate and then on one of its edges.Linearity error. Difference that occurs when the balance is loaded in a successive manner, increasing the amount of weight in equal magnitude until you achieve your maximum capacity, for then download it by following a process analogous to the above. The differences that occur between readings obtained and arithmetic values, corresponding to the weights used, are interpreted as the non-linearity. Error sensitivity. Constant deviation through the range of weighing or capacity deuna scale.Accuracy.
Sum of all errors in the balance. It is called band error tota.Hysteresis. Difference that occurs in the results when it increases or decreases the load on the scale.Linearity. For assistance, try visiting shimmie horn. A concept that applies to the capacity or ability of a balance to achieve accurate readings of weight of less than its total capacity masses. If is you draw a graph between weight, compared with the indication of weight in a perfectly linear scale, the end result would be a straight line. To determine the linearity of a scale error, certified masses should be used. The procedure for calculating differences of linearity consists of performing the same mass with no preload readings with certified masses. The difference between the two readings allows to calculate the linearity error.Mass.
Property of matter that is manifested through phenomena such as the attraction of bodies, using the force of gravity or inertia resistance to change the State of rest or low movement. The fundamental unit for expressing the concept of mass is the kilogram kg.Certified masses. Bodies which comply with the tolerances defined by certification bodies. ASTM standards 1 to 4 classes are widely used and are forced reference for calibration routines.OIML. Office International of metrology Legal.Sensibilidad. Smallest mass that can be detected by the scale. He is also understood as the smallest mass balance measured correctly.Traceability. Possibility of relating the measure of an instrument with unestandar defined group.